Metra Electronics Car Stereo System 99 8715 User Manual

INSTALLATION INSTRUCTIONS FOR PART 99-8715  
APPLICATIONS  
SMART FORTWO  
2008-10  
99-8715  
KIT FEATURES  
• DIN Radio Provision With Pocket  
• ISO Mount Radio Provision With Pocket  
• Double DIN Radio Provision  
• Stacked ISO Mount Units Provision  
KIT COMPONENTS  
• A) Radio Housing • B) Trim Plate • C) ISO Brackets • D) Double DIN Trim Plate  
• E) Double DIN Brackets • F) Pocket  
Harness & Antenna Connections (sold separately)  
C
B
E
• 70-1783 - Smart Car Harness  
• 40-VW10 - VW Antenna Adapter  
A
F
D
TOOLS REQUIRED:  
• Phillips Screwdriver/ Panel Removal Tool  
T-20 Torx Screwdriver  
1-800-221-0932  
© COPYRIGHT 2010 METRA ELECTRONICS CORPORATION  
 
99-8715 DASH DISASSEMBLY  
SMART FORTWO 2008-10  
A
1
Disconnect the negative battery  
terminal to prevent an accidental  
short circuit.  
2
3
4
Unclip the Hazard button switch panel.  
(Figure A)  
Remove (1) T-20 Torx head screw.  
(Figure B)  
Carefully unclip the panel surrounding  
the radio, start at the top of the dash  
and work your way down. (Figure C)  
B
5
6
Remove (4) T-20 Torx head screws  
from around the radio. (Figure D)  
Remove radio and disconnect the  
wire harness and antenna.  
Continue to kit assembly.  
C
D
1
 
99-8715 KIT ASSEMBLY  
DIN RADIO PROVISION WITH POCKET  
Note: Refer also to the instructions included with the aftermarket radio.  
A
1
2
3
Slide the DIN cage into the radio  
housing and secure by bending the  
metal locking tabs outward. (Figure A)  
Slide the aftermarket radio into the  
cage until it snaps into place.  
(Figure B)  
Snap the pocket into the radio hous-  
ing. (Figure C)  
Continue to final assembly.  
B
C
2
 
99-8715 KIT ASSEMBLY  
ISO MOUNT RADIO PROVISION WITH POCKET  
Note: Refer also to the instructions included with the aftermarket radio.  
A
1
2
Mount the ISO Brackets to the after-  
market radio using the screws sup-  
plied with the radio. (Figure A)  
Slide the radio/bracket assembly into  
the radio housing until it snaps into  
place. (Figure B)  
3
4
Snap the pocket into the radio hous-  
ing. (Figure C)  
Snap the Trim plate onto the front of  
the radio housing. (Figure D)  
B
Continue to final assembly.  
C
D
3
 
99-8715 KIT ASSEMBLY  
DOUBLE DIN/STACKED ISO  
MOUNT UNITS PROVISION  
Note: Refer also to the instructions included with the aftermarket radio.  
A
1
2
Cut and remove the center bar from  
the radio housing. (Figure A)  
Snap the Double DIN brackets to the  
inside edge of the radio housing.  
(Figure B)  
3
Slide the Double DIN or stacked ISO  
mount unit(s) into the bracket/radio  
housing assembly and secure the  
unit(s) to the assembly using the  
screws supplied with the unit(s).  
(Figure C)  
B
4
Snap the Double DIN trim plate onto  
the front of the radio housing.  
(Figure C)  
Continue to final assembly.  
C
4
 
99-8715 FINAL ASSEMBLY  
FINAL ASSEMBLY  
A
B
(A) Strip wire ends back 1/2"  
B) Twist ends together  
C) Solder  
D) Tape  
C
D
Locate the factory wiring harness in the dash. Metra recommends using the  
proper mating adapter and making connections as shown. (Isolate and individ-  
ually tape off the ends of any unused wires to prevent electrical short circuit.)  
1
2
3
Re-connect the negative battery terminal and test the unit for proper operation.  
Reassemble radio and dash assemblies in reverse order of disassembly.  
FINAL WIRING CONNECTIONS  
Make wiring connections using the EIA color code chart shown below and the instructions included with the  
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and  
individually tape off ends of any unused wires to prevent electrical short circuit.  
METRA / EIA WIRING CODE  
12V Ignition / Acc. . . . . . . . . . Red  
Right Front (+) . . . . . . . . . . . . Gray  
12V Batt / Memory. . . . . . . . . Yellow  
Ground. . . . . . . . . . . . . . . . . . Black*  
Power Antenna. . . . . . . . . . . . Blue  
Right Front (-). . . . . . . . . . . . . Gray/ Black  
Left Front (+) . . . . . . . . . . . . . White  
Left Front (-). . . . . . . . . . . . . . White / Black  
Right Rear (+) . . . . . . . . . . . . Violet  
Amp Turn-On . . . . . . . . . . . . . Blue / White  
Amp Ground. . . . . . . . . . . . . . Black / White  
Illumination . . . . . . . . . . . . . . Orange  
Dimmer . . . . . . . . . . . . . . . . . Orange / White  
Right Rear (-) . . . . . . . . . . . . . Violet / Black  
Left Rear (+) . . . . . . . . . . . . . Green  
Left Rear (-) . . . . . . . . . . . . . . Green / Black  
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.  
All colors may not be present on all leads due to manufacturer’s specifications.  
5
 
99-8715 INSTRUCTIONS  
1-800-221-0932  
REV.04/23/10 © COPYRIGHT 2010 METRA ELECTRONICS CORPORATION INST99-8715  
 

La Crosse Technology Watch WT 951 User Manual
Lenoxx Electronics Air Cleaner HC16 User Manual
Lenoxx Electronics Conference Phone PH 3235 User Manual
LG Electronics Air Conditioner W081CA SG2 User Manual
Lincoln Electric Welder SVM107 B User Manual
Lopi Indoor Fireplace Bostonian 564 User Manual
Makita Blower 4014N User Manual
Makita Cordless Drill BHR241 User Manual
McCulloch Chainsaw 41CY86AR777 User Manual
Melissa Styling Iron 635 120 User Manual